FXEngineering

Cycles

FXEngineering Pro Uppdaterad   
This is a modified Stochastic indicator. Modifications include:

1. The output is now centered on "0" and the scale is from -50 to +50, so that histograms and columns can be used to plot the output.
2. Added visual trade setup triggers. A trigger to the up side is a cycle high and indicates a "sell signal". A trigger to the down side is a cycle low and indicates a "buy" signal.
3. Added an alert trigger to be used to setup alerts. Selecting "Alert" to be Greater Than (>) Value = 0.00 will trigger an alert if either the buy or sell triggers occur.
4. Added a force indicator output. This indicates the rate of change in "D", or mathematically "dD/dt", as was done in the Power Analyzer indicator. When Force and D are in-phase, the maximum power is achieved.
5. Added "Slow Average Momentum" and "Slow Average Force" as was done in the Power Analyzer indicator.
6. Added an internal MACD and EMA as part of the trade setup trigger equation. There is a new input variable for the EMA length.
7. Added an input variable for the "Trigger Threshold", which ranges from -50 to 50, to be used as a screening filter.

Release Notes:
Updated trading alerts with new strategy.
Release Notes:
Updated user interface for greater control over the trading signal filters. Download the new companion, "Cycles Strategy" for backtesting.
Release Notes:
Updated buttons: Oct. 9, 2020
1. Revised text at button to enable/disable Higher close and Lower close Filter.
2. Added button to enable/disable %K Threshold filter. Revised text.
3. Revised text for Threshold %K and Threshold %D. These can be disabled by buttons or value settings, but the buttons over-ride the values set.
4. Revised to better match the Cycles Strategy.
Release Notes:
1. Backtested and updated trading signal algorithm. It now compares highs with highs, and lows with lows, and triggers when the candle action breaks above the previous lower high, or breaks below the previous higher low.
2. Updated initialization settings.
Release Notes:
Update timeframe alerts.
Skript med en öppen källkod

I sann TradingView-anda har författaren publicerat detta skript med öppen källkod så att andra handlare kan förstå och verifiera det. Hatten av för författaren! Du kan använda det gratis men återanvändning av den här koden i en publikation regleras av våra ordningsregler. Du kan ange den som favorit för att använda den i ett diagram.

Frånsägelse av ansvar

Informationen och publikationerna är inte avsedda att vara, och utgör inte heller finansiella, investerings-, handels- eller andra typer av råd eller rekommendationer som tillhandahålls eller stöds av TradingView. Läs mer i Användarvillkoren.

Vill du använda det här skriptet i ett diagram?